Usb virtual com port driver

Installing the virtual COM port driver. Connecting the device to a PC. Turn the transceiver power ON, then connect it to a PC via a connection cable for the transceiver. Confirming the COM port number. Open the "Device Manager" to confirm which COM port number is assigned for connection with the device. This USB2. Download and unzip.

To Uart Bridge Com3 driver direct download was. Entire USB protocol handled on the chip. No USB specific firmware programming required. Fully integrated clock generation with no external crystal required plus optional clock output selection enabling a glue-less interface to external MCU or FPGA.

Data transfer rates from baud to 3 Mbaud. Processor Architecture. WHQL Certified. Mac OS X This driver is signed by Apple. Mac OS X This is a Beta driver release and the installer should be run from the Applications folder on your machine. Then close the Device Manager window. If you want to confirm the port change has indeed been made, click on Device Manager again and check the listed Ports. Now close the System Properties window. At this point, you are ready to use the virtual COM port in any application!

Note that, if you unplug the USB device and plug it back in later, Windows will still remember the COM port assignment, so you won't need to go through this procedure again.