Installing a lyman 48

I would really like to pin down the facts on armory drilled and tapped NM rifles. I would very much like to have a "S" or C" stock NM rifle that could be documented as drilled and tapped.

In 30 years of collecting I have not seen any but maybe I have just not been in the right place at the right time. I would like to find a DCM documented and excellent National Match Special rifle; it is one of the key pieces I need for my collection. Page 1 of 2 1 2 Last Jump to page:. Similar Threads how barrels were really installed.

Replies: 4 Last Post: , AM. Replies: 1 Last Post: , AM. It's too tall? Replies: 8 Last Post: , AM. Replies: 7 Last Post: , PM. All times are GMT The time now is AM. All rights reserved. Image resizer by SevenSkins. Your IP Address: Mounting screws are included. You can read about it HERE. Your cart. I think I understand the windage adjustment but am totally lost on elevation, other than the mechanical act of doing so.

Anyone got a link or good source for information? As I know there are different models, a couple of pictures of my rear sight below. I tried sighting it in the other day at yards and let's just say my results were rather "modest"! We laugh at honor and are shocked to find traitors in our midst. The big hole is okay for minute of deer.

There is backlash in these sights so you have to move it enough to take up the slack when you change direction. To make an elevation adjustment, unscrew or loosen the knob on the front of the base. After each adjustment, retighten this adjustment. If this is unscrewed and pushed in- the arm can be removed by sliding it up.

Since this appears to be an early sight, rotating the elevation knob CW the elevation staff has a left-handed thread will raise the LOS line of sight and the bullet impact. If you are sighting in at yards and are shooting 2 inches low, simply rotate the knob clockwise two major marks on the elevation knob, or four detents or clicks.

Each division tick on the elevation scales represents one complete revolution of the elevation knob or five mminutes.

Savage Super Sporter Model 40 www. Springfield Armory Ronin 10mm Range Review Vintage Gun Parts - Lyman 48 Sale thea. This is an earlier Luyman No. Remington , , and Savage It is in used condition showing wear and patina.

Sold as is as a functional part with mounting screws included. All the knobs move freely. The numbers do not match on the inside A nice early Lyman 48 sight for the US Springfield rifle.

This one was made before they started making them for different rifles. Please note the early markings on the Early Lyman 48 sight issue - milsurps. This sight has the scale on the muzzle side of the bridge. My conclusion is that the base mount and the windage bridge came from two different sights. I consulted a colleague of mine who has a Lyman 48 Springfield sight and his assessment of this sight is Lyman 48 peep sight, Springfield Needs repair eBay Hot www.

Needs repair See original listing. Needs repair: Conditionnot specified. Ended: Jun 20, I tried reading Crossman's "Book of the Springfield" and read his detailed description and ended up getting a headache and needing to lay down! You might keep an eye on ebay for a used sight.

You could also modify one of the current production sights to fit the It is possible that Numrich might have one as well. Item Information. Conditionnot specified. Time left: d. Time left: 5d 03h. Bid Amount. Lyman 66 Receiver "Peep" Sights. Add to Cart Options.