Program a motarola p100

If you attempt to program an out-of-band frequency, the code plug WILL accept the information. However, the RSS will notify you that the frequency is out-of-band and to "Return the radio to Motorola for service". If, for instance, you convert an HT to amateur service, what is needed after programming is a field alignment.

This essentially consists of aligning the 4 receive helical resonators per channel for maximum noise, as well as adjusting the PA for each channel for maximum output. If aligned properly the receiver is quite hot. Attempts to go farther than this range will result in a very unhappy PA section and a very deaf receiver.

The only bad news is that the VCO is a sealed unit. These two Motorola Digital radios use the same programming cable, the same programming software, and can be programmed to customized frequencies. Watch the video below to see a basic overview of how to program your Motorola CPD two-way radios.

The easiest way to learn how to program your Motorola Radios is understanding the software. There are so many options available such as scan, alerts, push-to-talk tones, talk permit tones, and more.

The obsolete operating systems can usually be legally obtained from WinWorld. For convenience, we offer software for download instead of physical CD delivery. Software provided by Radiotronics is supplied free of charge. Any fee you pay to us in the process of obtaining software should be regarded as a "download and administration fee", which simply covers the cost of data file storage and the bandwidth used when downloading the software.

Any software Radiotronics provides will remain the property of the manufacturer and, whilst you are free to use it to configure your radio or device, you will NOT own the software. Only registered users can write reviews. Please, log in or register. Here are the categories this product is listed in. This may also give an indication of what this product is compatible with. Please note: All software purchases have to be approved by our team. For our propose, it's not necesary to do that.

If this doesn't work, just edit the dbf file located in Archive directory to replace entry for your codeplug and add this one captured here.

This is a 6 channel test codeplug, all of them has Out of band should work even with your codeplug, write some freq. Unfortunelly, this old radio has a narrow band VCO, very compact in a small metal case, and for ham band you probablly should break his case and increase the coil value somehow. Also, you must realign the Rx section wich is on some mosfet wich i saw, and Tx with a big trimmer First of all, read the radio and write down exactlly the actual limits of the software.

The low and high band stopers are just in hexadecimal notation, i. So, if you are looking for you should look for B1A occurence in the file. Another example is for wich in normal hexa is 8B3C and in the file you will find reverse 80C8B Just calculate your actual software limits in the same manner and write down on a paper. Calculate also the new ones your desired limits Replace ALL ocurrences finded in the file, but take care!

Remark, in the software the right conner on top the limits are original limits but, who cares..?! When you enter the freq.